TM Pro Plumbing is now proudly servicing St Helens Park and surrounding Campbelltown suburbs with leaking toilet repair in St. Helens Park, NSW
A leaking toilet was identified during routine maintenance in St. Helens Park.
We got a call to fix a leaking toilet at a residence in St. Helens Park not too long ago. The owner had seen water slowly trickling into the bowl and wanted it checked out before it became a bigger problem.
Long-term use of toilets often leads to this type of problem. Over time, the pieces inside wear out and start to leak. The homeowner wanted to get it fixed right away, even though it wasn’t an emergency.
Fortunately, they had already done the correct thing and turned off the toilet’s small stop valve. That meant that the water to the toilet was cut off, which stopped any extra water from getting lost until we got there the next day.
Knowing where your isolation valves are and how to turn them off can save you a lot of money. You usually don’t need to hire an emergency plumber if you can safely turn off the water.
What Was Making the Toilet Leak
We found that the inlet valve within the cistern had worn out and wasn’t sealing properly anymore when we looked at the toilet.
The inflow valve lets water into the cistern after the toilet flushes. It should turn off completely when it gets to the right level. These valves let water keep going into the cistern when they start to fail. From there, it pours through the overflow into the bowl.
Fortunately, this toilet had a properly installed overflow system, so the water didn’t leak. That meant that the extra water didn’t spill onto the bathroom floor; it just went into the bowl. If the overflow isn’t set up right, a leaking input valve can sometimes let water pour over the floor, which makes the problem much worse.
Why We Fixed the Whole Toilet Instead of Just One Part
The input valve was the main problem, but when we fix a toilet, we usually fix the whole internal mechanism at the same time.
There are many moving parts in toilets, and they all wear out at about the same time. If you merely fix the one broken part, it’s likely that another part will break soon after. That implies the consumer has to pay for another service call not long after the first repair.
To avoid that, we did a full toilet service that included:
All of the pieces that were put in were high-quality Caroma parts to make sure they would work with the toilet and be reliable. This method makes sure that the toilet is well-maintained and far less likely to have another problem in the near future.
The Toilet Service Process
Step 1: Cut off the water
The homeowner had already turned off the small stop valve next to the toilet. This safely cut off the toilet from the rest of the house’s water supply.
Step 2: Take out the parts of the cistern
We took off the lid of the cistern and took apart the parts within, such as the broken inlet valve and the worn-out rubber on the outlet valve.
Step 3: Put in new Caroma parts
We put in a new Caroma inlet valve, changed the rubber seal on the exit valve, and added a new flexi hose connection. It is crucial to use quality parts when fixing a toilet because cheaper parts often break sooner.
Step 4: Put it all back together and test it
We put the cistern back together and switched the water back on after putting in the new pieces. We ran the toilet through several flush cycles to make sure that the input valve closed properly and that the cistern sealed correctly. Everything was working wonderfully, and the leak was completely fixed.
Why It’s Important to Fix Small Toilet Leaks Right Away
At first, a minor leak in a toilet might not seem like a major deal, but over time it can waste a lot of water. A toilet that runs slowly might waste hundreds of liters of water per day. That not only makes water bills higher, but it also puts too much stress on plumbing fixtures.
Usually, it’s faster and cheaper to fix the problem right away than to wait until more parts break. The homeowner in this St. Helens Park project did a good job of handling things by isolating the toilet and scheduling a maintenance visit instead of calling for an emergency plumber. They saved a lot of money by taking that one simple step.
A Simple Plumbing Tip for People Who Live in St. Helens Park
One of the best things homeowners can do is understand how to turn off the water to each fixture. Next to many toilets is a small stop valve that lets you cut off the water in that area. If a toilet starts leaking or running all the time, turning this valve off can fix the problem right away.
This gives you time to set up a regular maintenance appointment instead of having to pay for an emergency call-out. One of the easiest methods to save money on plumbing is to know where your water shut-off points are.
Toilet Repairs at St. Helens Park
It’s best to have your toilet checked out before the situation becomes worse if you find that it is often running, spilling into the bowl, or producing strange noises.
TM Pro Plumbing fixes and services toilets all around St. Helens Park and the nearby neighborhoods. We work hard to fix the problem right so that clients don’t have to call us back. We can swiftly and reliably fix any problem with your toilet, whether it’s:
Call TM Pro Plumbing now if you need a reliable plumber in St. Helens Park to fix your toilet or do other plumbing work. We’ll be pleased to help.
Comments are closed